* Local variant for test
* a bit in between what was first and remote bitstream introduced a few
  commit ago. I don't knowwhat I will keep...

* The label name was not right.

* Parse every data in uint32

* Use alias to log, redirect command outputs to log
* Parse through uio names to find which is axiapp and ddr4, make alias
  link in /dev

* Usefull when we do not use DT_FROM_BD

* Add ChimeraTK generic server, uio backend and OPCUA CSA.
* Add script to configure and autostart ChimeraTK server.
* Use FPGA Manager to load bitstream, depending on user configuration at
  boot.
* Two variants of bitstream added: centralnode and cellnode.
* Add a begining of script to configure FPGA registers from a
  configuration file.

* This python script browse a simple file to write register using python
  deviceaccess.

* Remove DT_FROM_BD_ENABLE. We don't have anything particular in BD.
* Adding pl-conf.dtsi in system-top otherwise is gets lost and unused.

* Recipe parse & build errors fixed
* Use A proper init.d script skeleton
* change RC update params

* Usefull if rebuilding

* Use ch8, with correct address offset from AXI MM PS

* Add a link to the correct mapt file
* Add a default configuration

* Disposed on a shared URL

* This parse a configuration file and then load the FPGA with the
  correct bitstream (centralnode or cellnode)

* Else it is not possible to  make the device tree blob when several
  variants are given. Getting a duplicate node error.

* Turns ou I fail to make a /dev/axiapp pop in the FS... For now let's
  keep it as /dev/uio0

* Patch the .mapt file to set BAR to 0
* Add timers to xml config
* fix the device name

* This rely on the ChimeraTK GenericServer-OPCUA CSA
* It adds to the target filesystem the map and config files

TODO
+Script to launch the server at startup

* This generate a UIO device for the APP area.
* UIO is accessible in /dev/axiapp

It's better to fix it in Techlab layer.

* As we don't use block design, this IP is not detected automatically.
* The IP is located at a fixed address on the bus.

* Actualize the application
* No more BD inside
* Has a Debug Bridge at 0xA1000000

Struggling with petalinux update: it is no longer possible to log as
root without the tweaks.

From user diag, it is possible to sudo.

The one included by techlab-bsp matches their FPGA BSP.
I'm using MSK BSP

* move recipes to a identical filepath